doing hot bath for sauerkraut. Cleaning jar rims, adding more salt water to 1 inch of top, putting new lids and rings on jars. Screwing rings on tight. Put jars in canning, filling with cold water and bring to rolling boil for 30 minutes. When we turn off stove and remove lid to canner we are seeing most of the lids have bent in upward position. WHAT IS MAKING THIS HAPPEN?
Canning lids twisting
canning
Related Solutions
If you are seeing this effect after the jars have been in storage for a long period, do not eat the contents! This is a sign of botulism due to improper canning; the bacteria often (but not always) produce gas as they grow spores.
If this is happening immediately after the canning process, it is probably because you are not creating a proper vacuum seal. There are three accepted methods for doing this: Thermal exhaust, mechanical sealing (i.e. using a chamber vac) and steam displacement AKA steam injection. See the link for more information; the second two require specialized equipment, so thermal exhaust is what's normally done in a home setting.
In the thermal exhaust method, you get the contents very hot (71-82° C), which causes them to expand and release gases (air and carbon dioxide). After sealing and cooling, the subsequent contraction will create a vacuum seal. This is the most common method of home canning.
If you dump in hot brine and immediately seal the container, you are doing the opposite of this. Since the heat takes a while to distribute, you are causing this initial expansion when the jar is already closed, and this will force more gases up into the headspace and probably pop or warp the lid; if you're unlucky, it might even break the container.
Is this method safe? No. How unsafe it is depends on the acidity. Low acid foods must be processed in a pressure canner. That includes the majority of vegetables and especially garlic, peppers, etc. The main reason is botulism; the anaerobic environment is perfect for the C.botulinum bacteria, but spores cannot grow in high-acid environments with pH < 4.6. If the food is high-acid or has been acidified (i.e. pickled) then you don't need to worry, but with low-acid food you must kill all the bacteria and spores, and botulism spores are extremely heat-resistant.
In fact, they are so heat resistant that you cannot even kill them reliably in boiling water. That is why you need a pressure canner, to get the temperature all the way up to 121° C / 250° F, and you need to hold it there for at least 3 minutes. That is the only way to safely can low-acid food. Simply boiling it isn't good enough, and pouring in some boiling brine definitely isn't enough.
For high-acid foods, such as jams, a hot water bath is OK. This still involves boiling the entire jar after it's been closed, but you don't need a pressure canner. Pouring boiling liquid into a jar of cold or warm food will still not get the food up to a sufficient temperature, and even if it did, you would still need to sterilize the jar itself; that's done by boiling the whole apparatus. In this case you're not worried about botulism (since it can't grow in those conditions), but you still have to kill the other kinds of household bacteria, which don't have heat-resistant spores.
Since canning is intended to preserve the food, i.e. for long-term storage, you have to be a whole lot more careful about bacteria. You can't leave any opportunity for it to grow. Lots of people can the way your wife does and don't get sick, but it is a risky proposition, and I would strongly recommended you use safer methods, especially if guests or children are involved.
It sounds to me like the seal on the lids may be very slightly compromised. For example:
- lids start down with a good seal
- pressure can't escape and starts building up like usual
- imperfection in lid seal gives way a vents out pressure/heat, lid pops up
- jar/contents starts to cool, constricting, again like usual - this is what seals the jars in a normal procdure
- Lather, rinse, repeat
Edit
A thought occurs: it's equally as likely, if not more so, that the opposite of what I described above is happening: i.e., the stock is cooling down and contracting, which creates a negative pressure on the jar, sealing it. However, in a similar fashion to the above, a slight imperfection in the seal holds to a certain level of pressure but gives way past that threshold, allowing the pressure to equalize (which causes the top to pop up).
If they settled in the lid-down position after they completely cooled, they are probably okay (note the probably). What causes a lid to 'pop' after it cools is usually due to bacteria being sealed inside the can and/or compromising that can afterwards. Bacteria starts to eat the food, produces gas which expands and POP goes the lid, and your delicious canned food is no longer safe to eat. So if the lids stay down until you open the jar and the stock still smells okay, you're probably safe.
Best Answer
You should not put the bands on "tight".
From Fresh Preserving Water Bath Canning
Fresh Preserving Problem Solver
Condition: Lid buckles, appearing to warp or bulge upward under the screw band. If spoilage is evident, do not use.
When buckling is apparent immediately after heat processing, cause is overly tight application of screw bands. Using your fingers, screw bands down until resistance is met, then increase to fingertip tight. Do not force. Do not use a lid wrench to apply bands.