Oven – put the cast iron pan with wood handle in the oven

That is just the seasoning - the nonstick carbon that is formed after years of use - coming off. If big pieces are dropping in your food or you are freaked out by it, simply give your pan a good scrubbing with some steel wool and soap then re-season it.

To season the pan:

• Take a paper towel and soak a bit of oil into it
• Coat the inside of the pan with oil
• Put in a 250F over for about an hour
• Repeat each day until it has a nice shiny non-stick coating once again

Remember not to wash the pan with soapy water if you want the pan to stay non-stick. If there are bits of food in it from frying or such. Scrub it out with hot water and some coarse kosher salt, just nothing like steel wool, non-stick safe scrubbers are OK.

Adam

The usual heat transfer issues all apply.

What are those? Well, let me see

• The handle will warm up until it's total heat losses equal the total heat coming in.

• Heat comes in mostly by conduction from the body of the pot.

• Some materials conduct heat better than others. Metals tend to have high thermal conductivity (with aluminum and especially copper begin particularly good at it). Plastics and wood tend to be poor thermal conductors.

• Thick pieces of material can conduct heat faster than thin ones, but they also take proportionately more heat to increase the temperature, so this is a wash...unless you connect a solid handle to the body with thin spars (as in your upper photograph).

• The handle loses heat to the air by conduction (very little), convection (much more), and radiation (very little until it gets to hot to hold). For all of these having lots of surface area improves the rate at which heat can be dumped into the surrounding environment.

• Shape and orientation matters a lot to convective heat losses, but the dependence is too complicated to describe in a few words.

I find that bent sheet metal handles tend to stay cool, while solid handles get hot. If the half-n-half version you describe above has a pretty solid piece of metal that that part will behave very much like a all-metal handle (it may even be worse as the teflon will insulate the underside).

Short of taking detailed photos and constructing a model in a thermal simulation there is no rigorous way to know in advance. Still, if you've been cooking for long you probably have some intuition in this matter. Trust it.