I have a scissor jack and I was wondering if rather spinning it manually, if it is possible engaging it to my drill.
I'm pretty sure that there is an accessory like a hook for drills, or something similar, however I'm struggling to find it.
If there is no such accessory, maybe there is a combination of pieces which might sort my problem.
Best Answer
I would use a clevis pin like the image, with a bit of hex shaft welded into it for the chuck to grip.
Remove the safety clip and withdraw the clevis pin to allow the jack eye-hole to pass into the jaw, then push the pin through and secure with the safety clip. A spacer to reduce the play between the clevis pin diameter and the jack eye-hole diameter will reduce excessive play and wear.
I would make a shaft to go into the drill chuck from some hexagonal shaft - commonly available and likely stronger than grinding flats on some cheap jack handle...