I have a small ratcheting screwdriver as seen here, and a Leatherman multi-tool. I have also bought the Leatherman bit accessory pack that contains roughly 40 different bits.
I use both my ratchet and multi-tool a lot, typically for different things. However, on occasion, I noticed some tasks need the Leatherman, because only it has that specific bit. The draw back though, is I lose the ratcheting leverage. So for this type of niche task, I think it would be beneficial to buy an adapter that would allow my small ratchet to accept Leatherman bits. Leatherman bits are flat, rectangular bits, I have included a picture for reference.
Question: What kind of adapter do I need to buy to have my small 1/4" hex bit driver ratchet to accept Leatherman flat bits?
Best Answer
The Leatherman bits are standard hex sized only flattened. They should fit in any standard hex that is open or deep enough for the double sided bits to fit.
However be warned, without the custom sided attachment to grip the long thin side, the reduced surface area is more likely to round off the bits or the tool under significant torque.
Although Leatherman apparently doesn't think it's a problem as their bit extenders have a standard hex on the end and show it holding these bits.
