In a previous question we established that there probably should be a vent between my utility room (which opens into the kitchen and living space in general) and the outdoors (in my case the attic, which is a separate issue)
This seems hopelessly inefficient. Is there a better way to provide combustion air to the furnace and water heater, without having a direct vent between my living space and the outside air?
Best Answer
I am a little concerned that you are overthinking this situation. Naill C gave you some good advise in your last question. There are very few houses not built to be virtually air tight with an air exchange system that do not have enough natural air flow to support open combustion appliances.The simple act of opening a door to enter or exit the house allows large amounts of fresh air in during cold weather when windows are closed. Unless you have made extreme attempt to block all air infiltration, there is probably pleanty of combustion air passing through your louvered/slat door. I totally understand your desire to minimize heat loss from the rest of the house. Before any external venting will improve the situation, the utility room will have to be somewhat sealed from air flow from the living space of the house. In new construction a vent of a calculated size is brought in from the out of doors, screened and baffled, and strategically located just above the floor by the appliance. The mechanical room is almost air tight, insulated and lined in a fire rated material. Since this space is indoors and only calculated amount of outside air is allowed in, freezing is not normally a concern if water utilities are also in the room. Drawing air from an attic can be risky. Obviously some think it a good idea, however there are drawbacks. If the attic is not well ventilated the air may not be sufficient. I simple vent register in the ceiling to the attic will let as much heat up as it pulls air down. In fact, any open path into the attic can be dangerous. A register, vent pipe etc. can act as an easy path or chimney for fire or natural gas to spread quickly into the attic. If you decide to proceed in isolating and venting your open combustion appliances, pick one of the proven techniques and run it by your local building code officer for local compliance. Better safe than sorry.