I'm getting ready to finish my basement and one of the rooms is already roughed in. However, the stud walls are 1/2 (give or take) away from the concrete. My plan was to insulate with fiberglass but after reading found you should put XPS foam board as a vapor barrier/insulator. Do I HAVE to rip all of the framing out or is there a way to salvage what's been done?
Basement – Insulating existing basement wall
basementinsulationvapor-barrier
Related Topic
- Basement – rigid foam board in basement with exterior guard overkill
- Basement – Re-insulating/finishing a basement? options
- Basement – How thoroughly should I scrape paint from cement basement wall before insulating
- Water – Insulating Basement
- Shower – Should I install vapor barrier over XPS insulation panels
- Basement – Any issues with insulating exterior 2×4 walls with rock wool, then cover with XPS and drywall
Best Answer
Much depends on the dryness of your basement. For most basements, worthy of being made into finished living space, 3 mil. plastic sheeting between the framing and basement wall should be sufficient for this already framed room. The seems can be stapled to the inside of stud bays.
I'm not a fan of fiberglass batt insulation in basements, due to potential mold and mice issues, and, therefore, prefer XPS; which you could use for the yet to be framed rooms.
Some might suggest foam board between the framing and drywall but I don't care for drywall to be hung on the required, longer drywall screw. I guess it depends on the thickness of the foam board one uses. A heated basement shouldn't require much additional insulation as long as the rim joists are well insulated.