A piece of plastic melted on our dishwasher (66515113K216) heating element, and within a few weeks the heating element failed at that spot. We ran the dishwasher without a heating element for a few more months, drying the dishes by hand, before I ordered the replacement part.
Once installed, the new heating element didn’t work. I can’t imagine multiple things failed at once, unless the fault in the old heating element may have “blown” something else.
I replaced the high limit thermostat as it seemed like the most likely culprit, but no joy.
Before I go and replace every part in this dang thing, I’d like to apply a method to my madness. I do have a multimeter, and both new parts seem to conduct just fine (as does the original high limit thermostat, dangit).
Thanks!
Best Answer
Over the years I have bought brand new heating elements for dishwashers, stoves and water heaters that were no good. Remove the new element and check it for continuity. If you aren't familiar with this type of test, here is a Dishwasher Element Continuity Video. I would also check the resistance of the element. Turn your multi-meter dial to the ohms position. You should get a reading somewhere between 10-30.
The bad element could have caused an overload in the Electronic Control Board. This is the "brain" of the appliance. Remove the inside door cover to expose the wiring and make sure all of the wires are tight and not burnt. Smell the control board and see if you detect any type of electrical burn.