Can SDS drill bits be used with keyed single sleeve drills? If yes, are there any precautions I have to take for ensuring the best result?
Can SDS drill bits be used with keyed single sleeve drills
drill
Related Solutions
There are three different SDS sizes: SDS plus, SDS top and SDS max. You must match your tool type to the bits. Within a given tool type (SDS plus, say), the tool side is the same.
They are available in both inch and metric sizes (on the cutting end).
Wikipedia article on SDS shanks
SDS-plus, SDS-Top and SDS-max. respectively:
Impact driver? I wouldn't. Those bits are so small you'll just shatter them.
Regular drill? Maybe. Most drills max out around 1000-1500 RPM, although some specialty drill models max out around 4000 RPM. On the other hand, a Dremel usually starts at 5000 RPM and can max out around 30,000 RPM. So depending on the bit, you might get adequate performance. But most bits will probably be completely unusable.
Related Topic
- Realistically replace the drill with a rotary hammer
- Use old bits for a hand-powered drill in a power drill
- What set of bits is compatible with a Bosch Uneo (SDS-Quick)
- SDS drills with advertised chuck sizes
- Is it normal for a hammer drill bit to wobble
- Trying to decide between these two types of masonry bits
Best Answer
Your results will vary by the chuck configuration of your drill. You might get lucky; you might not.
If you chuck the bit in and it's wobbly, try shifting it a tiny amount -- it may work better. Be prepared to tighten the chuck frequently.
If you're drilling a lot of masonry, you might find an upgrade to a real rotary hammer drill (such as a Bosch bulldog) would improve your life a lot.