I'd remove the current steps, and then consider putting in new concrete steps. Maybe stain them or used colored concrete or perhaps tile them.
Concrete pavers aren't really designed for steps...and tend to be porous lower-grade concrete anyways. They make bricks for steps, but are a nightmare to maintain over the long haul as you are constantly re tuck pointing them--especially if you live in a freeze/thaw climate.
This was a project I did earlier in 2012. We wanted to install central air conditioning for our new furnace and there was no better place to put the outside unit than on this side of the house. Unfortunately, the pad there was a wedge shape. So I made a form and turned it into a rectangle. Couple hours of work including a trip to Home Depot for concrete.
Determine the depth of your pad - For mine, I used 2x6's to build my form. You should use a material that will determine your depth, ie: a 2x4 for a depth of 3.5 inches
Use screws to connect the wood together - this will make disassembly of the form easier when you're finished.
![Form](https://i.stack.imgur.com/Zxx7fl.jpg)
Mix the concrete per the recommendations on the bag.
![Materials](https://i.stack.imgur.com/8d7IOl.jpg)
If you're concerned about strength, you can use rebar rods or wire mesh inside the pour. Pour half the depth, lay the mesh or rebar, pour the rest.
Make sure the concrete is level or sloped if need be. A 2x4 can be used to do this or a wooden level. Make sure to wash the level when you're done.
Make sure to tamp the concrete down into the corners of the form and into the field of the form. You don't want any air pockets. Use a trowel to help move the concrete around. Use the edge of the trowel to help remove air pockets.
You want a nice flat surface. Use the level or 2x4 that spans from edge to edge to "screed" the surface flat. Use a flat trowel to raise a bit of water to the surface to make it nice and clean.
![Pour'd](https://i.stack.imgur.com/dZv2Dl.jpg)
Let the concrete set per the instructions on the bag - if the weather is colder, give it another day or 2.
Once everything is dry, remove the forms.
![Installation](https://i.stack.imgur.com/0TFFNl.jpg)
Best Answer
You could put tile on them. Or thick stone. Flagstone looks cool, and comes in variable thickness. Add thinner stone to the risers. You may not want to lose tread depth. Step it up a notch.