I'm using the Simpson PB66Z "Galvanized Post Base" to attach my pressure treated 6×6 to the footing. The wood seems to be slightly too large to fit such that the bottom of the post rests on the metal.
What's the proper way to handle this? I could pound it with a sledge hammer, shave some wood off on the two side corners, or something else? What is commonly done?
Best Answer
To follow up, I did use a sledge hammer to pound them into place. I placed a small cut piece of the 6x6 on top to prevent the post from getting messed up. It wedged it in there quite well.