I am hoping to be able to upgrade to a smart thermostat but unfortunately my furnace doesn't have the "easy" option with an obvious C terminal.
My furnace is OLD but it actually has the full 5 wires pulled to it although only 4 of them are in use/connected. All 4 are attached to the appropriately marked terminal at the Thermostat (see picture) but then it's a bit of a rats nest at the furnace so I am trying to figure out where the C wire would go to make the smart thermostat work.
Is there another wire I can piggy back off of at the furnace to bring the necessary power to the smart thermostat? Does anything in these pictures give you any idea where to attach the blue/C wire at the furnace? Any help you can offer would be much appreciated.
Thanks in advance and feel free to respond if you need a better look at anything from these pictures.
[![Solution?][5]][5]
Best Answer
Look for the junction of the thin white wire and the two fat yellow wires -- that's where your C is
Since you have an air conditioner in this system, we can use the wiring going off to the condenser as a clue to find your C wire -- the condenser contactor/control must be connected between Y and C as the thermostat switches R to Y to call for cooling.
Following this logic, we start with the yellow wire in the cable from the thermostat (it's the cable that terminates at the top of the picture), which is connected to the red wire in the cable going to the condenser (the cable that terminates near the bottom of the picture). Since that wire is clearly Y, the other wire in the cable going to the condenser (the white wire, since it's a two-wire cable) must be your C wire, and you can connect the blue wire in the thermostat cable there (after turning the power to the furnace off and stripping the wire end back, of course).