Copper pipe water line is out of round….can I still use a compression fitting valve and just add some teflon tape at the compression nut to ring seat fit. it is slightly oval. I noticed a slight wetness just behind compression fitting. I think I can reset it with a little Teflon placed over the ring setting where the nut stresses down on it.
Copper water water line is out of round slightly
copper
Related Topic
- Plumbing – Spigot/spicket replacement in tight quarters
- Water – Very slow leak out of main line at elbow out of concrete
- Plumbing – Copper Shutoff Valve Supply Line
- Plumbing – Do I need a regular Tee or a Slip Tee to add new line (pex) to existing line (copper)
- Plumbing Outdoor Copper – Dealing with Outdoor Copper Water Pipes
- Plumbing – Replace corroded copper water pipe
Best Answer
I do not think that teflon tape will help with an out of round tube in a compression fitting. My first thought would be to try to restore the tube to roundness by proper use of Vise-Grips with a rag to prevent scoring of the sealing ring. There is a die clamp device designed for gripping tubing to make a flare in the end. This die might be used to restore the tubing to roundness. You might have to remove the ring seal and put on a new one after truing the end of the tubing.
But be prepared to cut off the out of round end and join a fresh piece of good tubing.