drivewaygarage
I recently had a new asphalt driveway installed.
Due to the slope of the driveway they stopped about 2 1/2 feet from garage. This has created a problem with the end of driveway being 5 1/2 inches higher than the garage floor. This makes it extremely difficult to get motorcycles in and out.
Can anyone suggest a solution to fix this? I don't want any boards or anything like that but something that looks like it would belong there.
The gap exists for drainage. Technically, it's a gutter.
In order to create a level surface to drive on, you need to fill at least part of the gutter - but you need to do so without impacting the gutter's drainage ability.
Any permanent change you make WILL need to be permitted by the city/county, or they will likely make you take it back out again at your expense.
A not so permanent solution, however, would be to assemble a ramp structure which can be removed and which can support the weight of your car without impeding water flow. Something with a very rough design like this:
For the strength to surface area needed you're probably going to need to use metal. Unless you're a welder/metal worker this may not be a DIY project at all.
It's a cleanout for the sewer line. You can shorten it to grade level, but you cannot remove or pave over it.
You'll probably never need it, but if you do, you'll want quick access to it.
Best Answer
Looks badly done - grass should have been removed before paving, grade fixed if needed so water won't run from driveway into garage.
For a crude fix, place a slot drain right up against the garage to divert water, and infill with lots of "cold patch" to make the slope inbetween as smooth as possible, rather than this huge drop at the end of the pavement.
For a better fix, hire a different paving contractor...