doorsoutdoorpatioproduct-recommendationreplacement
I live in the Boulder Colorado area where we have hot intense sunny summer days, and below zero freezing winter nights. We are planning to install a sliding patio door in a south facing full sun area. I am also concerned about damage to the outdoor frame, as our current sliding door leaks during intense rain storms due to cracked seals and weathering.
What are some of the things I should look for when searching for the new sliding door?
If the door panel, the moving part, is not clad (covered with metal) on the outside, the easiest way to remedy the problem is to plane about an 1/8" off the door itself. The weather-stripping is part of the jamb so it will not be affected. The interior side of the track will have a few screws holding it place. I see one screw hole in the picture, looks like it is missing the screw. Remove the rest, that piece should come out, and the door panel with it. If there is a place in the jamb where the door is loose compared to the other places, move the door to there to get the top to tip out, it will be heavy...
As a note I would draw some concern why the head is dropping, unless the bottom sill that the door rides on is rising. Either will cause the same problem. Swelling wood from leaks in the siding or flashing or other things that happen over time.
Although this will not address the potential problem, that is, why the head has dropped, if that is why the door head drags, you may be able to run a few 3" screws into the track at the top and draw it up a little, that way if there is any room for it to go up, that will make that happen. Do not put the screws in the middle of the jamb, do put them in the middle of the operable track that the sliding door panel rides in. Headers are usually made with 2 pieces, with a 1/2" space in the middle. That's why no screws in the middle.
If the sill is raised up, check to confirm with a real true, stable, straight edge. If it is riding up in the middle, that is bad, usually there are no ways to send a sill down, usually they are set in sealant, and gravity does the rest. Very few have screws set to them, it is a leak potential.
Just short of doing something like below, I think the best you can make sure of is:
Best Answer