Drywall – mount a TV on a single metal stud

Do not use drywall anchors to hang a TV that large on a swivel mount. If it was a mount that didn't have motion, I might say that's acceptable, but not with a swivel mount.

You will need to use wood in some form to add the necessary strength.

Plywood can be attached to the wall studs using 3-1/2" lag bolts with fender washers. To provide a clean finish, the drywall can be cutout and the opening filled with the plywood. Then tape and mud the joints. Sand the surface smooth, prime, and paint. The plywood will be barely noticeable if done right. Be sure to match the plywood thickness to the drywall thickness.

If you do not want to remove any drywall, the plywood can be mounted directly over the drywall. You will need to use at least a 4" lag bolt in this case to account for the extra depth of the drywall. The plywood can be finished with a routed edge, sanded, primed, and painted for a finished look, if desired.

A final option for a truly hidden mount would be to open the wall by removing the drywall. Then install 2"x4" crossbracing between the studs at the correct locations for your TV mount. Replace the drywall, tape and mud the joints, sand, prime, and paint. The bracing is now hidden in the wall and you can attach the mount to the bracing.

Toggles and other heavy weight drywall anchors can be suitable for TV mounts when the mount is flush. Or toggles in to metal studs. Since the load is mostly shear and not pull-out, this is fairly safe. (Provided the drywall is thick enough, the anchors are installed correctly, the wall is properly supported, and lots of other considerations too numerous to go in to here.)

However, adjustable, articulating or arm mounts should never be used on just drywall or metal studs. No matter what anchor you use, drywall and metal studs can not handle the pull out force applied when a TV is extended or tilted away from the wall.

So either get a flush mount, or open the drywall and install appropriate wooden studs.