boltsceilingdrywallsafety
Unfortunately the ceiling ceiling joists run in the wrong direction.
I was wondering if I can use toggle bolts to support ~50 pounds of faux wood beams on ceiling dry wall.
It would be about 4 toggle bolts across a 16.5 ft ceiling holding up ~50 pounds of weight.
Go ahead and place the drywall over the top edge of the crown moulding. Sounds like the wall was already re-plastered with it in place. If you tried to remove it, you may end up re-doing the walls as well. Even forgetting that, it's almost impossible to remove moulding without sustaining some loss. Without replacement material available, removal with intents of preservation is extremely risky, especially with stain grade material. You don't want to go there.
If your joists were flat, you'd still only need to shim down the first 4 feet or so along the walls, no one will see the resulting slight slope. Keep this in mind when planning your shims. It doesn't have to be perfectly flat, unless that gives you pleasure. You also don't need to shim to completely fill the gap. An 1/8" gap makes a clean shadow line that is not detrimental (assuming it is perfectly uniform) at all. It also makes finishing easier. The taped joints of drywall are normally not perfectly flat, despite the tapered edges. There is a slight bulge which is usually invisible. But against straight moulding, depending on the profile, this bulge may be visible. You might consider grinding down the edge tapers at the board corners against the wall so the joint tape can be completely buried and the yet the joint against the moulding can still be perfectly flat.
I felt like using SketchUp, but you can easier secure it to the ceiling or wall.
I roughly used the dimensions on the Impex Marcy SM2805 Suspension Rack
The drawing is based off of a few 2x6's and only 1 cable support is shown but there should be 4. This would run roughly $100:
DO NOT GET PRESSURE TREATED LUMBER
You should never used pressure treated lumber for indoor uses.
Best Answer
Is there an attic above that leaves the joists accessible? Add 2x6 blocking between the joists to get the support you need. Toenail the blocking to the joists on both sides of the blocking. Then you can fasten the faux beam to the blocking rather than the drywall.