Wondering if there are any suggestions for a safe additive that can be flushed into a sewage ejector tank that can help break down waste (even toilet paper). Getting some awful foul smells – going to double seal it with another layer of silicone, but would love suggestion on an enzyme/other type additive that helps break it down
Sewer Septic – Safe Cleaning Additives for Ejector Tank
septicsewer
Related Solutions
Most sewage ejection pumps have two cords. One is the power for the motor. The other goes to the float switch. The power cord is a regular plug. The float switch cord has a plug on the end with female on one side and male on the other. The power's plug is inserted into the female side of the float switch plug. The male side of the float plug is then inserted into an electrical outlet. When the water level trips the float, the float's plug "opens" to give power to the motor's cord. If you want to test the pump manually, find the outlet the cords are plugged into, unplug the motor's plug from the float's and insert the motor's plug directly into the outlet, bypassing the float. When you're satisfied, insert the motor's plug back into the float plug and insert the float plug back into the electrical outlet.
You have a clog downstream of the pump most likely. It might have even died because of this (overheated?).
You will need a drain auger/snake in order to clear this. If it's close to your access point you might be able to use a small handheld one, but most likely you'll need an electric drum snake:
You can rent these from most home improvement stores.
Best Answer
Additives don't help much, if at all.
Check gaskets and seals, as you've stated. Also check the stack vent: The ejector pump tank must be properly vented. This is true of all waste plumbing, to prevent buildup of gases.
For some other tips on reducing odor, see InspectAPedia.