we just moved in to a new apt in New Jersey and the previous tenant had this really nice string light fixture with colorful lampshades etc (pictured below). Unfortunately, he took them with him when he left. My girlfriend and I want to DIY a light fixture that is essentially string lights wrapped and hanging from a wood beam that will be hung from the ceiling. However, the issue is all the lights she bought are traditional plugs that you would plug into a wall outlet.
I keep getting so many different answers on the right way/wrong way and complexity of turning the hardwired into an outlet so we can run an extension cord from the ceiling down to a surge protector which will be hidden on the beam and used to plug in the 4-5 string lights she has
here is what the outlet looks like. I'm wondering how complicated this is, what I would need to do it and if its something better left to an electrician.
thanky you so much in advance
this is what the fixture currently looks like[![3][3]](https://i.stack.imgur.com/AeMm7.jpg)
Best Answer
Judging by the photos and your explanation, it shouldn't be a complicated job but there are a few things to take into consideration:
Local code compliance in New Jersey and your county/city - something I'm not familiar with.
How well you can make wire connections yourself. I've seen many DIYers and "electricians" wire connections and they were varying levels of "lucky nothing happened yet" to "lucky only this part burned when you called me".
If you're confident in your wire connections lasting for 50 years+, its basically installing an outlet with a plate that fits that 4-O box (my trade slang for what I assume is in the picture). It should be properly grounded to be up to national code, so you'll need to know how to check for that. The pipe may already be the ground for it.
I'd hire an electrician for something like this because you get their expert knowledge/skills and its probably a couple hours at the most. Could be less than an hour if you have all the infrastructure in place minus the outlet/plate. To save a few bucks, you could always install the fixture yourself since you just need to plug it in.
If you do do this, here are some options/ideas:
You could use plates like these (for example):
https://images.homedepot-static.com/productImages/e888bbe3-2fa2-40e3-8112-08feb4fa3864/svn/brown-leviton-electrical-outlets-receptacles-5059-64_1000.jpg
You need to identify which wire is the switch leg and connect that to the hot screw. The neutral would go on the neutral screw. If you have a solid ground path through the pipe, you could use the ground screw in the threaded hole in the box. Otherwise, you would need to run a ground wire back to the closest ground source to make it properly grounded.