electricalfluorescentlighting
I have a few HF-Performer III TL5 ballasts to to which I connected cables in past. Now I can't take them out
The instruction on the housing says that:
– just rotate and pull, but it does not work when I keep them with my fingers and do so, maybe there is a tool for this?
– this is an ADS / Manual connection, but in Google I can't find anything about this connection
On the pictures you can see a ballast with plugged cables and without cables
I ask for you advice
My guess would be that because the fixture has a metal frame, the ballast is grounded via its contact with frame. If the frame were plastic, you would need to use the terminal on the ballast.
If you're converting it to hardwired, you should definitely connect the ground wire to the grounding screw.
You're also going to need to cut a hole if there's no punch-out available and make sure to use a cable clamp/strain relief suitable for using with romex.
After reading Jimmy Fix-it answer I decided to give it a try to modify the Model 9000 fixture for installation of LED tubes in the Model 9000 fixture rather than throwing it away, and found the way to do it, as explained below.
The end caps are two-part plastic sections held together and mounted to the metal chassis of the fixture by plastic tabs. Besides a flat screwdriver of the proper size to work the tabs loose, you will certainly need patience and will to remove the end caps. Anyway, if the alternative given is throwing the fixture away, you don't have to be so worried that you could break something.
Photo 1 shows the two parts of the end cap of the fixture that has the input cable disassembled. It will give you an idea of where the tabs and the holes they fit into are located. Once the parts are removed you'll want to cut the wires that come out of the tube sockets as long as you can. Pull some of the red and the black wires that go to the other side of the fixture to cut them longer for easier connection. After cutting the wires you will be able to remove and discard the three parts shown removed in Photo 2.
Then strip the wires (Photo 3) and connect them as shown in Photo 4 with wire nuts.
You will connect the wires in two three-wire groups. Connect one wire from each of the two tube sockets to one of the wires of the supply line. Then connect the remaining wire of each socket to the remaining wire of the supply line.
Check continuity to ascertain that each socket has one side connected to the load line and the other side connected to neutral. It doesn't matter which side is which as long as each socket has one side connected to load and the other to neutral.
You will want to push the wire nuts into the spaces that the parts removed occupied. Then reassemble the end cap sections and mount them to the fixture. Reassembly is very easy; sections will slide and snap together in place.
With the wiring connections described above you MUST use Single Ended Power (SEP) LED tubes. Since the socket at the other end of the fixture will only hold the LED tubes in place you may cut and discard the long cables going from one end of the fixture to the other.
Hope this can help and you don't have to throw the fixture away. As you may have noted there is no cost for this modification except for the cost of the two LED tubes.
Best Answer
The solution is to use pin. Put it above cable end and remove both pin and cable at the same time
(On last picture it is below, not above)