I am installing a new Leviton Dimmer Switch (model number DW1KD) to replace a normal wall switch. My electrical to the existing switch has only two black wires (I do know which is hot), and a ground wire. The Leviton Dimmer has 5 wires, but only 4 (black, white, green and red) are required to be connected for a single pole install. My dilemma is, where does the red wire go? Currently I have the hot black cable connected to the black wire on the dimmer, the white to the other black neutral wire, and the green to ground. This does power the switch itself, but does not turn on the light. Can anybody tell me how to hook up the red wire in this instance??? Thanks in advance for your help!!
Electrical – Leviton Dimmer Switch Model DW1KD
dimmer-switchelectricalelectrical distributionswitchwiring
Related Solutions
Why would you replace a single pole dimmer with a 3-way switch?? I pity the next person who tries to figure out what the heck is going on with this.
Correct replacement would have been - leave the wires that are connected to each other connected to each other. Remove dimmer with one in, one out - replace with switch with one in, one out, connecting wall wires just as they were connected to the dimmer.
What you are looking for is a single-pole, 2-wire dimmer. That's a fairly standard item. An indicator light is a little less common, but not impossible to find.
Since you only have 2 conductors in the switch box, your switch is probably wired like this:
Related Topic
- Electrical – Replacing light switch with dimmer switch… white wire
- Electrical – Replace 3-way Dimmer with Timer Switch
- Wiring – Which Neutral for a Single Pole Leviton Dimmer
- Electrical – Wiring a 3 way Leviton VPT24-1PZ Vizia 24-Hour Programmable Light Switch
- Wiring – How to connect the dimmer switch
- Wiring – Replacing older Leviton dimmer with new Lutron different wiring
- Wiring – Help: Replacing a Leviton Dimmable switch with a Regular Switch
Best Answer
From the description provided for the existing old switch it sounds like that was wired as a simple switch loop. As such there is no NEUTRAL in the switch box. The HOT black lead is bringing the line into the box and the other black wire is connecting out to the load (light). That load black wire may actually be a white wire that has been sleeved with a black tubing, painted black or taped with black electrical tape.
From the installation sheet for the DW1KD the switch is a smart switch and will require a NEUTRAL in order for it to function.
You will not be able to get this to work with the existing wiring. Since the HOT is clearly off in the electrical box at the light you will have to work out running a new cable from the light box to the switch box that has a four conductors (HOT - Black; NEUTRAL - White; LOAD - Red; GND - bare wire).
From the above diagram note that the Red wire of the new switch goes to the load. The Black wire on the switch goes to the HOT entering your switch box. The White wire from your new switch has to be connected to the new NEUTRAL that will be provided by the new cable that you need to run.