I installed a new dishwasher, and now I'm at the point where I need to wire it As a temporary measure, I just wired an appliance cord, and ran it to an outlet. To do that, I'm running it to an extension cord, out a cabinet, and above the dishwasher. It's not ideal. Rather than put in a new outlet under the sink, I'd like to hard wire the dishwasher to its own circuit on the panel in the basement. My question is, can I drop the Romex through the floor behind the dishwasher? I know that if you run it to an outlet, the outlet has to be in a separate cabinet, so you can access it without pulling the dishwasher out. The issue is that it's going to be a real pain in the butt to send it into the wall, then drill a hole down to the basement. It would be much easier to send it through the floor behind the dishwasher; I just want to make sure that's okay before I do it that way.
Thanks!
Chris
Best Answer
I have done that, hole in the floor back near the wall,
MC Modular Whip to a junction box in the crawlspace and then romex from the junction box to the panel.
I did not hard wire the whip into the dishwasher, i installed a surface mounted metal outlet box and connected the whip to that and then a regular appliance cord from the dishwasher to the outlet.
The appliance cord will make the installation and removal of the dishwasher easier as the MC is stiff and will cause problems.