Electrical – Two power sources, one 3-way switch

electrical

I am attempting to build a charging station for all of our electronics. I would like to set it up so for each device there is a light switch and an outlet for its power adapter.

If it is switched one way, it is straight power like it's plugged into the wall. If it is switched the other way, it will go into a timing circuit where it will only get power for 2 hours a day (to maintain charge when not in use).

I would I have a 'timed hot' (T.H.) and an 'always hot' (A.H.) supply line entering the circuit but I am not sure where to go from here as far as the rest of the wiring.

Is this possible and if so, how?
Thank you so much!

Best Answer

I personally think you are going way overboard with what you propose. These days all your newer stuff charges with 5V on USB Type A connectors. The charge controllers inside your phone / tablet / GPS / whatever else are smart and will service the internal battery in the proper way. So there should be no need for this two hours per day timed behavior.

So if you have five devices to charge get one of these. For ten devices get two.

enter image description here