I bought a used washer and dryer about a month ago from a warehouse dealer that specializes in used appliances. The dryer worked for about a month then refused to operate. I called the appliance guy who checked the dryer, said it was fine. He was able to hook up another dryer which he was transporting which also failed to turn on. He left the new dryer and took the old one to his shop where it turned on fine. He blamed the outlet or some part of the electrical and insisted the dryers are working fine. he has offered to let me take any same price dryer from his shop and try it.
I told the landlord something may be wrong with the electric. He came and checked the breaker, tested the voltage, couldn't find anything wrong. Multi-meter showed 120 from each side to neutral and 240v across both. Breaker is fine, but he replaced it to make sure. Dryer still doesn't work.
I called the appliance guy back who took the dryer apart to look for a fault. Nothing. Tried a third dryer, no luck. So I call the landlord back who replaces the three prong dryer outlet which results in no change and insists his wiring is correct.
So we have tried three dryers that work at the warehouse that don't work at home. The outlet provides 240v but the dryers refuse to operate. Supposing the appliance guy isn't outright lying and these dryers work fine when plugged in at the warehouse, what might the landlord be missing in the electric lines? He is a very handy person but admittedly not an electrician.
If I need to get in person help would it be better at this point to contact an electrician to look at the lines or an appliance guy to check the dryer?
Best Answer
I recently had a problem that stumped me. My dryer had worked for a couple of years and then stopped heating. Turns out, the 240 receptacle had a bad contact on one of the 120 legs so it made poor contact with the plug. I replaced the receptacle. Later, I autopsied the old receptacle, cutting it open by drilling out the central rivet, and found that one of the spring clips had actually broken, so it didn't maintain tension. Of course when I had probed the receptacle I had been able to get the 120 because I was hunting for it. Perhaps your receptacle is bad?