electricalledlighting
I have a 5050 5 meter LED strip and it requires an AC/DC adapter to run the full strip. I was told that I needed a 2A adapter, but I went to electronic store to buy an end adapter and they said this adapter was not powerful enough to run this strip and that it requires a 6 amp. I want maximum light without any concern of over heating.
Which is right?
Not a complete answer, but here's some more info.
While there are ways to calculate this that aren't that complicated, it requires knowing many coefficients that are not readily available, so ends up being an educated guess at best. You can do just as well totaling your current lighting's lumen output, then adjusting for changes in fixture styles. (I consider even a simple LED strip a "fixture" for the sake of this discussion) It's a starting point. If you use proper task lighting, there's a lot of room for variance in total levels.
You do not want to see the actual LED elements, it's really annoying. Besides diffusers, indirect lighting techniques work well, though require more lumens due to losses through reflection.
I'm not sure what the issue is with parallel surfaces. The efficiency is mostly inherent in the fixture's ability to direct light where it's needed. The mounting surface has little to do with this, you need to direct the light where it's needed.
The "whiteness" is measured in degrees Kelvin. The temperature a black body must be heated to emit the same color of light. Standard daylight is often taken to be 6500K, anywhere in the 5000-7000 range is close enough for most tasks. You eyes adapt quickly to small variances. In residential settings, daylight is considered too harsh because we are so accustomed to incandescent lighting, so most home lighting is produced to output more in the 2000-3000K range to mimic the orange incandescent lighting.
How audible the noise is varies by manufacture and environment, as well as personal temperament. I don't think noise data is readily available. Testing in a noisy store will not yield any useful data, other than if you can hear it from a few feet away it is too loud. Noise can be attenuated by placing it in an enclosure, but keep in mind power supplies generate heat that has to be removed by ventilation, you cannot seal it into a sound proof box.
Try to place power supplies as far from your pillow as possible, trying to sleep is when it will be most bothersome. Placing it lower so there is likely to be more furnishings obstructing a direct path will help, as well as being surrounded by soft materials that do not reflect sound as well.
I'm not familiar what that product specifically, but the "amplifier" in this type of lighting setup generally only reads the input from the previous upstream light strip and provides power from its power source. Therefore, the amplifier draws no current from the upstream lights.
Instead of 2 power supplies, you could use one power supply larger enough to satisfy all of your power needs.
To answer your questions specifically:
Best Answer
Assuming the 2A was correct, then you really cannot go wrong with the higher AMPS and more AMPS will not make the LEDs overheat. AMPS will simply provide more available current to the circuit. This can give you more scalability if you decide to add more lights later on. More AMPs does not translate to higher power consumption either.
Hopefully these illustrations help:
You could go seriously wrong, however, if you over-volt them and it will make them overheat or destroy them altogether. If batteries are involved then there may be some considerations about AMPs.
More reading:
Good info that directly applies to your question.
This is about speakers but the same principal applies.
This is also good info