Electrical code requires that all junctions be accessible in a box, so you definitely need one here. You have two choices (that I know of at least):
- drill a small hole in your siding and mount one a weatherproof box on the outside:
The exterior boxes come in a range of depths and colors so you should be able to find one you like.
Strictly speaking, that round metal mounting bracket on the back of the fixture is supposed to be secured to an electrical box.
It can be a shallow box, but it's supposed to be a box. You must protect the wires. You want that new garage to still be there 10 years from now.
I can't really tell from the photo, but the right shallow metal box should fit within that recess on the back of the fixture without you needing to cut a hole in the siding. But if you have to cut a hole, then you have to cut a hole (if you do, rent, borrow or buy a holesaw for your drill big enough for the box).
You could attach the box through to the OSB with screws, although personally, I'd lay a 2x4 flat side against the OSB inside the garage, toenail it into the studs on both sides, and screw the box directly through the OSB into that 2x4. So a stiff breeze or errant basketball doesn't knock your light fixture off the wall. :-)
Drill a hole through the OSB and the 2x4 big enough to feed the cable and to accommodate the clamp that holds the cable in the box. The cable has to be clamped into the box.
Then attach the round mounting bracket that came with the fixture to that box, wire everything up, attach the light fixture to the bracket that you attached to the box. That's the way it's designed.
If it's a metal box, it has to be grounded (screwing the grounded mounting bracket to it will accomplish this).
You also have to secure the cable inside the garage as dictated by your local electrical code.
Finally, I'd use a dose of waterproof silicone or caulk around the box, and then again around the fixture itself after it's mounted, to make sure water doesn't seep inside.
Good luck!
Best Answer
Use a mounting block with a built-in box
The simplest solution to this problem is to use a siding mounting block with a builtin pancake box, such as an Arlington 8141 (the correct part number depends on the lap depth of your siding, the 8141 is what's used with a 1/2" lap) or equivalent.