I bought some LED lights for my candelabra in my master bedroom. They're E12 bulbs (I think, since they do fit). Incandescents worked fine before. When I put these LEDs in there, they flicker when they're off. They work great ON but why would it be flickering when off? What possible solutions do I have? This is 1999 home, not too old.
Here's a video of my problem. I use a remote to turn off and on.
LED in question. I also tried another brand from Home Depot, but same results.
https://smile.amazon.com/gp/product/B06XY8LM1G/
Best Answer
You say that you control the lights with a “remote” and there is no smart switch. Sorry to tell you, but there must be some sort of smart switch which is receiving the signal and controlling the light. It may be part of the light fixture.
Anyway, smart switches that don’t connect to a neutral wire have to get power by trickling current through the load. This works well with incandescent lights because they require quite a bit of current to light. LED light bulbs instead require very little current and contain driver circuits to run off of mains voltage. The low trickle current will charge a capacitor in the driver so that when they charge, the light will flicker on and discharge the cap.
Unfortunately, your remote receiver is not compatible with LEDs. You might be able to make it work if you put in one incandescent bulb along with the LED bulbs as it may be able to prevent the LED drivers from charging. Otherwise, you will have to remove the receiver or replace the fixture.
Or, just keep with incandescents.