Flooring – is there a trick to installing “lock and fold” flooring

flooring

I am doing a small installation of lock and fold flooring and find that the pieces don't want to sit flat, they curve up from the floor somewhat. I am tempted to push harder on them, but don't want to break the tongue off. Should I be using a rubber mallet to set the pieces together or is that too heavy handed for this stuff, it isn't very thick and it was expensive so I really want to be careful.

Does anyone have any tips for installing this type of flooring? It is turning out to be a little more hassle than they advertised on the display in the store.

Best Answer

I can think of a few possible problems:

  1. The floor wasn't flat to start with. You typically put down an underlayment of some sort, which will deal with some floor imperfections, but it's not 100% perfect.
  2. Something managed to get under the flooring when you weren't looking. (those little plastic things yout put against the wall being a prime culprit, but those are pretty obvious when it's happened).
  3. There's something in the grove of flooring. As part of the manufacturing, a little wood chip might get in the track, which prevents it from seating correctly and locking down.

Odds are, it's #3 -- it doesn't take much. Inspect the board that you're trying to place, to see if there's any imperfections in the board along the grove, then take a look at the place you're trying to lay it into. One the last floor I helped installed, we got in the habit of looking at all edges of the board before laying them, and pulling off any bits that were flaking that might cause problems later. We also found that putting the board in the groove, then running it back and forth a few times would make them more likely to sit down on the first try (I'm not sure if it knocked out debris, or ground it down so it was small enough to not be a problem).

Related Topic