I wanna start by saying I'm learning I'm by no means an electrician. with that said I would.like to know if I hooked this gfci to switch up correctly for a garbage disposal. the garbage disposal is to be plugged into the gfci and ran by the switch. I ran a new line to the gfci and hooked that up then ran splice wire from white and connected white from switch and Same for the hot and grounded all to green nut in back of box
Gfci outlet to switch for garbage disposal
garbage-disposalkitchen-sinkreceptacle
Related Topic
- Wiring – A GFCI outlet controlled by a light switch
- Switch – Constant Power to Garbage Disposal
- Plumbing – Sewer smell after installing garbage disposal
- Electrical – Need to add an outlet under a sink (for garbage disposal)
- Electrical – Wiring outlet with a switch for garbage disposal
- How to properly terminate dish washer / garbage disposal
- Garbage disposal plugs up all the time
Best Answer
I do not think you did it correctly but I will explain.
Connecting the GFCI without a switch all sounded good. But you then put the switch on the white or neutral if I understood your question.
The proper wiring would be the “splice” to the switch if a piece of Romex is on the hot to the outlet , you remove the black line feeding the outlet connect that to the white of the Romex and mark that white at both ends with tape or a sharpie. That reidentified white connects to the switch, then the black in the Romex “splice” connects to the other side of the switch and at the outlet on the hot / line side.
I think you switched the neutral side this is a code violation. We re-identify the white and have it always hot so someone later doesn’t mistake it for a neutral. But that is the proper code compliant wiring for a switch leg. (+ grounds and while the breaker is off but you know that).