I have a bunch of try/combination squares that I would like to store/hang in my work area but I cannot figure out a good system. Can someone recommend a good method to keep combination squares readily available and protect them from getting damaged? I would like to have at least the following within reach of my bench:
- 1 × 6 inch try square
- 2 × 12 inch try square(s)
- 2 × 12 inch combination square(s)
- 1 × 24 inch protractor square
- 1 × 24 inch straight edge / ruler (bonus points)
Updated information to address question:
I do have a pegboard in front of my bench. That is what is so confounding. I have not been able to think of a way to securely store/hang them on the peg board. Despite the existence of the peg board answers do not need to utilize the pegboard.
Best Answer
If all your tools are steel or other ferromagnetic material, I would try something like this:
It's a magnetic knife holder that you should be able to buy at any kitchen store.
Alternatively, you could build something along the lines of a traditional knife block by glue-laminating pieces of wood and leaving appropriate gaps for each square. Although, some types of squares might not fit.