My automower have been opened too many times/with too much force, so the thread is gone some places.
Could I use some building silicone I'm the holes, or will it come out the next time I unscrew?
Best Answer
I think you're right that using silicone or some other filling compound would just come out after unscrewing a few times. Personally I'd look at replacing what I assume was a self-tapping screw with a metal thread screw and use a threaded insert such as the following:
So just drill out the hole a bit for a tight fit of the insert and add a little epoxy to hold it in place. Alternatively you could try to do a similar arrangement using a standard nut by drilling to a fairly shallow depth at the bottom at a diameter just large enough for the nut and using epoxy to hold it in place.
I doubt it would be a serious issue unless you really mixed in the canola. However, if it does become a problem next time use plain water. Water in the air is actually the catalyst that drys silicone, construction workers will take a cup of water and dip their finger in it to smooth silicone on things like bathtub installations so that the silicone won't stick to their bare finger.
Silicone or the Duct Sealant are fine. But, either need to be protected, faced, supported & sealed with Aluminum Foil Tape, the real duct tape. Before anything though, you need to solidify your duct joints (supplies & returns), they can't slip apart or slide & deflect in any direction. Just sink short self-tapping duct screws (sharp pointed ones, not the drill-head ones) through the joint's 2-pieces to lock everything together.
Best Answer
I think you're right that using silicone or some other filling compound would just come out after unscrewing a few times. Personally I'd look at replacing what I assume was a self-tapping screw with a metal thread screw and use a threaded insert such as the following:
So just drill out the hole a bit for a tight fit of the insert and add a little epoxy to hold it in place. Alternatively you could try to do a similar arrangement using a standard nut by drilling to a fairly shallow depth at the bottom at a diameter just large enough for the nut and using epoxy to hold it in place.