sprinkler-system
I have a corner in my yard that is getting too much water from the sprinkler system. The grass is drowning and moss is growing because it's constantly wet. The adjacent zone seems to throw enough water on that spot. Can I somehow cap off that one rotor, or will I need to completely remove it?
If capping, is it a matter of replacing the rotor with a cap. If removal is necessary, will I need to remove that whole spur pipeline, or can that branch just stay in ground full of water?
Ok, I'll admit, I'd just buy the sprinkler head. Let someone else do the work of engineering it so that it would work consistently on demand, because this has to work thousands of times, day after day. It must survive variable water pressure, be robust to working in a dirty environment, hard water, heat and cold. Any water system sometimes even has grains of sand, etc., that find their way into the lines. So you must cater to that possibility.
You need a filter. Materials that will be dimensionally stable under temperature variations, without corrosion. A robust design that will not leak, yet survive enough water pressure to spray the water where you need it.
If your goal is to do better than what you would find on the shelf, and this is truly for your own DIY use, then buy it off the shelf, and dissect that unit. Look carefully at it, and decide what makes it work or not work to your satisfaction. I'll admit that I don't think you can make it better for less money than the unit cost you off the shelf. The fact is, you have not said what it was that makes you think the off-the-shelf unit is unsatisfactory to YOU.
If your goal is to try to make something like this better for sale to others, then you are asking in the wrong place anyway. In that case, this question should then be shut down.
A picture would make it easier to help, but I would guess the white "nut" you see is probably the PVC female adapter that is glued to the pipe.
If you can do it, the fastest fix is to unthread the nipple from inside the hub, then just replace it with a new nipple.
If you can't do that, you'll have to cut the adapter off, and then glue a new one on (PVC glue is permanent -- once it sets, it's never coming apart). If there is enough room you can just glue a new adapter on, and then get a slightly longer nipple to keep the sprinkler head at the same height.
If there's not enough room, you may need to dig it up some more, cut the elbow or T below off, and replace everything.
Best Answer
It depends on where the sprinkler head is located within that zone. If the sprinkler head that you are capping is not a dead end on the line, then you can cap it at this sprinkler head. If it is a dead end, then you need to go to the prior sprinkler head to cap the line.
And you do not replace the rotor with a cap but actually just remove the sprinkler head and cap the line. Removing the sprinkler head is very easy to do. Just get a trowel and dig down around the sprinkler head until you have enough clearance to unscrew the current sprinkler head without getting soil in the line.
But before you start the work on capping/removing this sprinkler head, I would try adjusting either the current sprinkler head or the other zones sprinkler head to reduce the amount of water being delivered to that spot. Depending on the type of sprinkler heads you have, you might be able to replace/adjust one or both of the sprinkler nozzles to reduce the flow. Or look into adjusting the pattern on the sprinkler to deliver less water in your area. Or you can even reduce the amount of time that one of these zones is watering. My point is that someone already did all that work to install the line and sprinkler so try some other steps first. There have been plenty of times that I have planted a tree or plant or did some other landscaping that blocked a sprinkler heads spray area and then wished I had another head in that location.