My chainsaw stopped working and I've got a tree that fell and needs cut up. Does anybody have any idea what I can do to get my chainsaw started? I've done a bit of stuff on cars so I'm willing to try to take it all apart, though part of me is tempted to just drop $200 for a new one. Still, an afternoon tinkering isn't going to cost me much. Here is what I tried:
So Far:
- check gas in tank Add Star Tron or Stabil Fuel Additive
- check for spark with screwdriver.
- Check Air Filter / intake for clogs
- Check Fuel Filter / to cylinder.
- Check linkages for Start/Stop and choke levers are operating
- Clean Magneto of Rust, ensure it holds a screwdriver up.
- Clean carburetor and fuel lines, especially if it may contain old fuel.
It's a husqavarna about 5 years old. I ran it hard 3 years ago when I had another tree topple but it made it through, though I may have vapor locked it once. It's also not been running since I failed to start it last year and it's been sitting there. With the spring I need to get on it before the weeds come.
Best Answer
Most two cycle engines are sensitive to the newer gasoline blends that can contain up to 10% ethanol. Get a small bottle of fuel additive for small engines and add a small amount of that into your gas tank. It should run a lot better after that. I had a similar problem with my leaf blower last year and this did the trick.
Star Tron is a much better brand than Stabil by the way.
If you are still having trouble and you have already checked the spark plugs, sometimes the magneto can have a buildup of rust on the surface that prevents it from generating enough current to sustain repeated firing of the spark plug as the engine turns. Take apart the pull start mechanism on the chainsaw until the magneto is exposed, and take a fine grit sandpaper to it to rub off all the rust that has formed on it by sitting all these years. To clarify the magneto is the part that is magnetic, it should grab your screwdriver.