maintenancerepairtools
I have a hand tool – Needle-nose plier that had a rubber that is used as the handle. Currently, I managed to clean up all the rust on the metal and would like to clean up the rubber handle as it is sticky and dirty.
Should I use baking soda mixed with a little water as a paste to clean up the rubber handle or should I buy a new rubber to replace that old rubber?
I think what you need is a Palm Nailer. You can get these in air or electric powered versions. They are compact and are handy to drive nails in tight spaces.
I would inspect the exhaust/flue pipe. If it is an older type made of regular steel it may be corroded and the source of the rust. High efficiency burners can produce an acidic exhaust. They sometimes require a stainless steel flue or at the least, routine. replacement
Best Answer
I don't think you want to use an abrasive on rubber/plastic coatings, and re-coating them is a bit extreme. So before you try either of those, try some Goo Gone* - it's usually safe, and will get the goo off.
*I have no affiliation with the company, just a satisfied customer.