I want to remove a roughly 18' beam that goes across my garage. Oddly, it's the only one at this level. The ceiling beams are all about 28 inches higher. When I touch this beam it wobbles quite a bit, though it's firmly attached at the ends, leading me to believe there isn't much if any load on it. It seems like the beams above it are doing the same job. What the heck is it doing there, and how can I figure out if it's safe to remove? I'm hoping it's just there as a byproduct of the building process or something.
One potentially interesting note: I measured where the beam would come into my house (to the right of the garage as pictured) and it looks like it would come i directly above my front door. Interesting?
Edit: the "suspicious rope" was installed by myself just prior to taking these pictures; I was about to cut the beam and didn't want it to fall. Then I thought I'd better take a moment to reconsider, and here we are 🙂
There was previously a garage door opener which I removed; it ran just under this beam and wasn't attached to it. There WAS an electrical ground stapled to it (can be seen in the pictures) which I moved up to the beam above. I can't imagine someone would install a 2×6 just to run a ground when the beam above serves just as well.
Best Answer
From studying your picture it appears to me that the timber is intended to tie one wall to the other. If so, I would be asking why. A couple of clues I would look for are:
Is the height of the placement of the timber, on each end, possibly where the top plates of the framed wall are, behind the drywall? ( As opposed to the studs inside the wall running from the floor plate all the way up to the roof rafters.) If so, this connection between lower studs and upper studs could be a weak area for lateral wind loads to cause some unwanted flexing of one of the walls.
You mentioned your front door was on the other side. Is it possible that the front door wall, beyond, is located in a sturdier wall that has sufficient bracing and the timber in your garage is using the strength of that wall to tie the opposite garage wall into something more stable. If that opposite garage wall is an exterior wall subject to wind I would think that might be the case.
There are some DIY things you can do to experiment with it a little bit. Try flexing the timber back and forth to see if one wall stays rigid but the other moves just a tiny bit. If so, that would indicate that the wall that moved needs that timber.
A good framing carpenter ( think This Old House) could probably access your situation adequately. Maybe for free if it is easily apparent to them what is going on and they can give you an estimate for any modifications that would enable you to remove the timber.
Hope this helps. Good luck!