I've tried turning, and the light cover is loose but no matter how much I turn it, it is not coming off. Any help/tips would be appreciated.
Best Answer
It likely has a spring / pressure / snap connector and is not a screw on type of fitting. We can tell that it's not a screw on since it's the same no matter how much or what direction you turn it. Try carefully prying it to one side or the other from the top of the light cover while holding the light base so to not put force on the connection of the fixture to the wall. More than likely it will just pop out. Don't be shy with the force, it might take a little, while of course being careful not to break or damage anything
Pull the spring-loaded prong away from the dome, and tip the dome below it - then pull the dome away from the other two prongs. Don't push the spring-loaded prong with the dome.
Simple geometry says that the required distance of movement to get
one prong clear is considerably less than what's need to clear the
ones at 120 degrees from it.
Trigonometry quantifies that to about half, if I'm constructing the
problem correctly in my head.
Best Answer
It likely has a spring / pressure / snap connector and is not a screw on type of fitting. We can tell that it's not a screw on since it's the same no matter how much or what direction you turn it. Try carefully prying it to one side or the other from the top of the light cover while holding the light base so to not put force on the connection of the fixture to the wall. More than likely it will just pop out. Don't be shy with the force, it might take a little, while of course being careful not to break or damage anything