Let me start off with a diagram
This is the projector screen in front of the wall. The vertical bars are the studs.
- There are probably 4 or 5 more studs between the edges of the screen).
- The frame of the projector has about a 3" gap from where the keyhole slots or loops for hanging are located.
I'm trying to figure out how I can attach the projector screen to the wall or the ceiling. I don't seem to be able to attach it to the wall because of the positions of the studs. I would only be able to attach to one of the studs with brackets or a screw.
I would prefer to hang the projector from the ceiling, but the joists run parallel to the wall, so the nearest one is 18" from the wall, which is much too far for where I'd like the screen to hang.
Best Answer
Rather that attaching into the drywall or cobbling up short mounting blocks I would strongly recommend that you mount a board to all the existing studs that is just a bit longer than the width of your screen.
This board can be a straight forward 1x6 pine board (actual dimensions 0.75" x 5.5"). Since you want the screen up near the ceiling anyway just slide the board all the way up against the ceiling and attach it with screws right through the drywall and into the studs. This will make a nice sturdy place to attach the hangers for the screen. Once it is all attached in place the board can have holes filled with filler or spackle. Then prime and paint to a color that matches the wall.
Note that once the screen is hung in front of the board it will hardly be noticed that the board is there and it will still look nicer than other kludge solutions.