I'm planning on updating the casing (ranch style currently) on several door frames in my house to a craftsman style and I'm not sure how the trim will fit near the hinges.
Right now the reveal (R in the picture) between the edge of the and the casing is just about 1/4", maybe 1/16" – 1/32" under. The edges of the hinges are just about even with casing, sometimes overlapping by ~1/32". The center of the hinge pin comes out from the outer face of the jamb 9/16" (D in the picture).
If I put the craftsman trim up with the same 1/4" reveal it will be very close to the hinges, just about touching really. If I use 9/16" thick trim it should have a little clearance from the hinges because of the radius on the trim. But I think I may use something a little thicker than 9/16" so it comes out from the baseboard trim a little on the bottom, in which case the door casing would be right up next to the hinge.
Is there a typical way to work this out? The only way I really see is to have a larger reveal.
Best Answer
The simple answer is that you adjust the reveal to accommodate your hinges. Whether you do this just on the hinge side or all the way around is up to you. It looks like you'll want to paint the jambs before installing the casing anyway, so it shouldn't be an aesthetic problem. Sand down the paint ridge a bit so it doesn't show.
It shouldn't take more than an extra 1/16" to clear the hinges, and even if the casing is against the hinge you're unlikely to have problems.
I absolutely would not carve out for the hinges. This looks amateurish and sloppy, in my opinion, as though you failed to plan well.
Of course, you could always replace your hinges--modern ones tend to have smaller barrels, but I think that's unnecessary. It's also often more hassle than it sounds since screw patterns and leaf size are not standardized.