I am trying to insert rebar into the ground to hold an art project. I cannot get it straight. I am starting with a drill bit, then hammer, then fence post banger. I is angles every time. Suggestions?
How to keep a rod vertical as I drive it into the ground
rebar
Related Topic
- Concrete – How to prepare the site for a concrete step
- Concrete – How to drill to insert rebar into a large rock (5mx5mx5m)
- Hammering a rebar into the ground without bending it
- How much shear load can rebar withstand
- Concrete – Cut rebar in concrete
- How far into a footing pier should rebar extend from the rock below
- Walls – How to Prevent Rebar from Rusting in the Ground
Best Answer
Put the rebar into the ground so it comes out a few inches.
Then connect to it with the uprights etc that you need using bolted joints. That way you can get them upright irrespective of the rebar angle.