I'm digging up my sprinkler valves for what is probably the 3rd time in as many years. I'm replacing this valve on the right which isn't closing to cut off the water properly.
I dug for about 2 hours through clay and rock to get this far. And it's 100 degrees outside so I had to stop.
Can I replace these circular round box with a big valve box? The purpose being less digging next time another valve needs to be replaced. Ideally I could leave these pipes exposed so I don't have to push all this dirt back again.
Are there any other ways to make this job or future jobs easier? I feel like this setup is a huge mess. Especially compared to setups I've seen on youtube demonstrations.
Best Answer
I would definitely go with the bigger valve box. Also, think about using the compression repair sleeves. It makes the repairs and replacements so much easier and you can use them over and over. Good luck./