The external cladding of my house is rendered NRG Greenboard (an EPS product). What is the best way to mount simple external hardware (specifcally, a hose reel) to this material?
The reel itself just came with 4 screws that are meant to affix it to the external wall of the house, but it seems like with the EPS it wouldn't take much force at all to yank them straight out. What's the recommended procedure for mounting things securely to the EPS?
Best Answer
NRG greenboard is 98% air and therefore only 2% polystyrene
NOTHING can be mounted TO this. Your reel may be mounted THROUGH it to the studs behind.
Since this didn't happen, you have to add the blocking EXTERNALLY.
The typical 50' hose full of water is at least 15 pounds, the reel another 10 pounds and the pulling on the hose another 25 pounds or more, so you need a sturdy solution.
You would do well to distribute this across 2 studs, perhaps using 2 2x4 treated lumber. The screws would need to be long enough to go through the boards, outer covering (I hope the house isn't only covered in greenboard), the green board and at least 1" into the stud. Weather proof decking screws (ceramic coated for rust) would be a sturdy choice and come in 3", 3 1/2" and 4" lengths. All screw holes should be pilot drilled and filled with an exterior caulk or an exterior silicone.
Once the support boards are mounted to the studs, the reel can be attached to the boards with the original hardware.