I have 2 metal poles 10 ft poles and a metal entrance gate that is 10 ft wide and 4 feet tall. I want to get it in the ground this weekend. I am going to rent a gas post hole digger. What kind of cement and how much do I need? I read somewhere that it is a quicker idea to pour the mix in the hole and 2 gallons of water on top of that.
Can I get a step by step directions on how to put this in the ground?
How to put in a 10 ft metal pole for a metal driveay gate
fence
Related Topic
- How to build a privacy fence
- Concrete – How to rebuild a large fence gate
- How deep in ground should I install 4×4 PT fence posts
- Concrete – Cement Recommendations for Fence Posts
- Concrete – How long should concrete set for a post before I perform additional work
- Right tool to drill a 3 to 4″ diameter hole approximately 3ft deep through remnants of a ground up tree stump
- Concrete – Contractor is installing a vinyl fence and posts but is not using any water with concrete. Is he doing it right
- Wood – How to replace loose 4×4 wood fence post with a steel post
Best Answer
Depending on the weight of the gate and your climate gate post holes are dug deep enough so as to not be effected by frozen ground heave. If you are located in this type of climate than 48 inches should be your goal to avoid having the posts disturbed by frozen ground forces. If you reside in a mild climate than 18-24 inches will suffice. The diameter depends on the diameter of the post, but figure for a 3-4 inch post drilling a 5-6 inch round hole. To help keep the post from possibly loosening the last 3-4 inches of the hole bottom should be widened to form an undercut (or a bell shape) making it wider at the bottom. A gas powered auger will save much time and labor. You will still need a hand operated post digger to remove the last of the dirt. Be forewarned hitting a rock will be a jolting experience even with a clutch. Once you have excavated a post hole to the proper depth insert the post. It should be positioned (if you drilled exactly) approximately in the center. You should support the post so that it remains in position while the concrete sets or you make adjustments. Any length of lumber or rebar that is available will do. Attach two opposing braces close to the top of the post (wire will fasten to anything well). Using an appropriate sized level, check the post for plumb alternating from 90 to 135 degrees on the pipe circumference (side to side and front to back). Adjust the support brackets to keep the post plumb. You should have at least (6) 60 lbs. bags (or equivalent) on site to fill a 48 inch deep x 6 inch diameter hole. Mix two bags at a time in a wheelbarrow following the directions for the amount of water (I believe it's 2 gallons per 60 lb. bag). When completely mixed shovel into the hole. After every 4-5 shovels tamp the concrete with a 2 x 2 or 2 x 4 to compact the mix and remove the air. The job will be most successful if you mix and pour the concrete without letting it set up. Fill the hole so that the concrete is a few inches above grade. With a trowel round off the concrete so it tapers away from the post. Finally, don't forget to inscribe the date and your initials in the still wet concrete. You can remove the post supports the next day, but let the concrete set a few days before hanging the gate.