Winter is finally over, and it's time to remove the cover from my above ground pool. However, snow and rain have left quite a bit of water on the cover.
I see three options
-
Pull the cover off, and let the water go into the pool.
-
Use a garden hose, and try to siphon some of the water off.
-
Buy a pump, and pump the water off.
The water on the cover is gross, so I'm not sure I want to just let it go into the pool.
I don't know if siphoning would work, as I'm not sure I'd be able to get it started, or if it would continue to flow once started.
Haven't looked into buying a pump yet, so I'm not sure if they're expensive, or how much electricity they consume. I'd also have to monitor the pump, so it didn't run dry. Which doesn't sound ideal.
Is there a tried and true method that pool owners prefer? Or any methods I haven't mentioned?
Best Answer
My family had a pool that would be covered over the winter. We would use a simple garden hose to siphon the water off. The siphon would be started by putting one end in the pool and filling the hose up through the spigot. When it was disconnected it would start siphoning immediately.
The end of the hose was put in a beach play bucket with a brick in it so it would always be the lowest point and not get air in it.
We'd have to clear leaves and detritus occasionally from the hose end, but usually the leaves were decomposed enough that they'd flow through the hose.
Sometimes we would use the pool vacuum hose, but since it was so big (1 1/2" OD) it was hard to get a siphon started.