How to repair a rotted door threshold

door-frametransition

Recently the wood transition strip at the door from my garage to the backyard came loose. When I pulled the transition strip it appears the underlying wood is rotted, how would I go about repairing this?

enter image description here

transition strip

Edit: I'll say what what I know might be underneath. This is the ground floor. I don't believe out basement extends under any part of the garage. My garage has a tile floor installed by the previous owner (she ran a kennel out of house before we bought it so all the rooms, not just the garage, had this crazy tile!). I presume the tile is on top of concrete based on what I can see at other parts of the garage where the tile ends) The red brick is the outside of the house, and the pavers were installed directly on the dirt by the landscaper.

Best Answer

To do it properly you're going to have to pull up that aluminum door sill to see what's going on underneath. It appears that water has been seeping under the door sill from the outside and has rotted part or all of the underlying door frame. It's also possible that the water is coming in along the perimeter jambs and seeping down to the sill. To remove the aluminum sill you're probably going to have to remove the door stop trim on either side of your door. If you do it carefully you can probably re-use it.
The sill may be glued or screwed on. This will expose the wood sill frame underneath. The wood sill will be attached to the jamb on both sides. It may all be rotted or just part.
To replace it you'll have to cut it out at the jamb on both sides or if it's only rotted along one length you might be able to remove the compromised part with a chisel. Let the area dry out removing any rotted portions. You can then replace/repair the wood sill with new wood by attaching it directly to the framing underneath as a support for the aluminum sill.
You can then reinstall the aluminum sill and the adjustable threshold that came up - you probably will want to replace it with a new one. it's critical that you weatherproof around the aluminum sill with exterior silicone caulk. You also should caulk the entire exterior perimeter of the door and it's trim and make sure the weatherstripping around the door, especially at the bottom isn't leaking. Until you weatherproof it the problem will only recur and get progressively worse.