Is it safe to remove risers from stairs

There are 2 ways to do this, the first way is in essence just cutting the wall at the top of the skirt board and capping it off and setting the handrail on top of the cap that is finishing off the cut wall, sounds a bit crude, but essentially that describes what you will have.

The up side to this is you will not need to do a floor repair, depending on where your wall ends where the newel will be.

The other way to do it is by removing the wall entirely, repairing the floor, removing the treads and risers, and set longer ones with return nosings on either side. and re-support the stairs with a new walls under the existing carriages.

This is the most work, but will give the best result in my opinion.

Jan. 2, 2014 edit

Here is the work I did in 1989 that shows what I did. This one shows the best example of the effect I was trying to explain. I do not have a shot that shows how the handrail goes past the ceiling, but with a little imagination you could picture what the rail would have to do if the stairs were much wider at the bottom.

Edit #2

I did a little calculating to help, if it may

If you are running a hand truck as part of a specific project, tape rosin paper to the stairs, and be careful when going up and down. You can buy this at a hardware stores.

This also works for floors, though masonite boards underneath work well.