Kitchens – the generic term for kitchen counter laminate without particle board

Cutting the countertop to length:

Try making a custom circular saw jig to cut your countertop to size. 3/4" plywood placed together at right angles with a cleat for guiding your saw should give you a straight cut. Assemble the jig with extra material, then cut it to size with your saw for a perfect fit.

Use a saw blade with a high tooth count and cut the counter upside down. That way, the blade teeth are traveling down (but really up) into the counter surface, minimizing chances for chipping out. Start by cutting the backsplash first, with the rest of the counter pointing towards the floor. Then stop and rotate the countertop so it's upside down and finish the cut. Be sure to support the cutoff material so it doesn't break off a chunk of the laminate near the end of the cut.

As @auujay points out, masking tape can also help reduce the likelihood of chipping.

Source: woodworkingtips.com

Cutting the sink hole:

I crawled several forums looking for advice on this one. Some suggested techniques (in the order that I would try them) were:

• Use a jigsaw with a down-stroke blade to cut out the sink hole. By cutting on the top surface, you have a more accurate picture where your sink hole will be, and the downstroke blade will eliminate chip-out. Start each rounded corner with a 1/2" spade bit.
• Use a jigsaw with a metal cutting upstroke blade. The finer teeth will make for slower work, but have less of a chance of chipping.
• Use a circular saw to cut straight sides from underneath the countertop. Flip over and finish the rounded corners with a downstroke jigsaw blade.

Once again, use masking tape for both cut line visibility and to reduce the chance of chipping the laminate. Also remember to support the cutout section to avoid tearing the laminate near the end of the cut.

First, take off all the doors, drawers and counter tops. Many times, counter tops are glued to your base cabinets, and are bolted together at the seams with pocket bolts. Try to take these off carefully if you plan on re-using them, or donating them too.

Then, look for a board near the top of the base cabinets, this is the board usually used to screw the cabinets to the wall. Take the screws out that are being used to secure them to the wall, and it's likely that they'll can just be pulled away from the wall. Be careful though, sometimes, the base cabinets are screwed to each other too, so look at the insides of the base cabinets to see.

The same basic process can be done for the upper cabinets as well, except that you should make sure that they are not screwed to each other before trying to take one down. This is almost always a two-man job.

As for donations, I suggest looking for a Re-Store in your area. They are operated by Habitat For Humanity, and I personally have purchased many things (including cabinets) from them. All the proceeds from the sales of donated items goes to help low-income families earn the pride of home ownership!