How do I go about changing this lightbulb?
The frame won't come out and there's no spring to pop out the bulb?
Any and all help is greatly aplreciated!
Lighting – How to change recessed lighting with GU10 light bulb
lighting
Related Solutions
It looks like it just pulls down, there are usually little springs that keep it in place. Like the one pictured below
I ran into the same problem - everyone said it was spring loaded but even with considerable force the bulb barely moved. But as one person says above, you only need the bulb to move slight to be able to remove it. You will note that on one side there is a gap in the white plastic holding the bulb in place - in the photo above, you can see the gap on the right side. That is where you slide the bulb out of the holder. Put on leather gloves, push the bulb towards the other end and then slide the bulb out through that gap.
Related Topic
- Lighting – How to change the bulb in this three-clawed, ceiling-mounted dome light fixture
- Lighting – How to change an untwistable (by design?) fluorescent tube light bulb in a fitting with no slot
- Lighting – How to replace this recessed light bulb
- Lighting – recessed light only works with halogen bulb
- Lighting – How to remove this recessed light bulb
- Lighting – How to Change this Burned Out Light Bulb
- Lighting – change the light bulb to an LED multicolored light bulb
Best Answer
You have to pull the outer potlight trim frame straight down and out of the ceiling. Then you will be able to access the bulb from the back side.