I got a Murray mower with a Briggs and Stratton 500e 5 HP engine from a friend. Not sure how long it may have been sitting, but I can start it first or second pull. After it starts, it runs slow, unless I tilt it back until the handle is level with the ground. When it's tilted back it runs like normal, but then it cuts off because it stops getting fuel after a few seconds. I've already cleaned the carb, replaced the gas, checked the fuel filter, checked spring tension on the throttle/choke rod (no actual choke, just a spring attached to a rod to hold the door in the carb open) and that is fine, and I checked the air filter/cleaner "sponge" and that looks clean and the engine runs the same with or without it. Only thing I haven't checked was the spark plug, but I don't think that would be the issue because it runs fine while it's tilted. Does anyone have any idea? Or should I just rebuild the entire engine?
Murray mower with B&S 500e engine running strange
enginelawn-mower
Related Topic
- Toro ready start lawn mower dead
- Lawn mower runs for a few seconds then stops
- My push lawn mower will start when primed, then it dies unless I tip it backwards
- Self propelled mower loses power then slowly dies when self propel is engaged
- Electrical – Diagnosing faulty ignition coil on lawn tractor
- I hit a pipe with a mower and now it won’t turn
Best Answer
For those symptoms, I'd initially suggest that the fuel tank and fuel-line need a flushing and cleaning. The tilting back remedy typically means the fuel tank's screen filter is mostly clogged...assuming it has one or some type of filter.
I don't know the specific engine, but very related to the above is a fuel-bowl attached to the carburetor and most especially the Jet-Bolt that attaches them together.
The fuel-bowl needs to be clean and the Jet-bolt needs to be poked clean with a pin and then blown or flushed clear.