Non woven geotextile fabric for french drain clogging in heavy clay

drainage

I did a lot of research on french drains before I hired a landscaper to put one in a month ago. Followed advice of the French Drain Man and used 4oz non woven geo textile fabric. I also had standing water in a low spot 15 ft away from french drain so I installed catch basin, shoveled a ditch, laid non perf corrugated pipe and laid it perpendicular to the ditch of the Fr drain burrito wrapping fabric thinking it would percolate thru the fabric and into the fr drain pipe. I left the intersection area open so I could look down and see if it was working. During Heavy rain last night I checked and found the both catch basin area and the intersection open hole flooded with water. This morning I baled out the hole and found water is pooling/standing on top of the fabric and not moving thru it. Pricked fabric with T pin multiple times but the flow is very slow when I subsequently tested it. Does heavy Kentucky clay when wet form a non permeable layer of mud on the fabric? If so then the whole Fr drain is not working! Not from KY so I am amazed at the type of clay here. Bad stuff!. Originally installed Fr drain due to water in crawl space. Some water did come in after this storm but it appears to be less than before. Anyone ever see slow to no percolation in non woven geo tex fabric in heavy clay? Also need advice on what to do. Additional info: Drain installation: ditch lined with fabric all sides and bottom, laid in perf corrugated pipe, filled ditch with #57 rock up to 8 inches below ground level, burrito wrapped fabric over the top of rock/pipe and covered with fresh topsoil.

Best Answer

You want water away from your basement wall and your solution, which often works, is indirect, you're attempting to drain all the water away, rather than the water you care about.

A solution is to keep the water away from the exterior of the basement wall using a waterproof coating on the exterior of the wall, and then a drainage board over the coating. Then, set up your foundation drain to drain the water AFTER it gets through the filter covering which is outside the drainage board. This eliminates the clogging issue. If the filter clogs, you're happy because the water isn't getting to the basement wall.

For the other issue, treat it separately by continuing the non-perf pile the entire distance.

a type of drainage board