We just moved into a new house. We had a plumber come out for a non related issue on out oil burning hot water heater and brought these corroded valves to my attention that he said needed to be replaced. I see the corrosion and am wondering if these can be cleaned up or if they really need to be replaced. If they do need replaced can it be done safely by myself? If it needs to be done by a plumber or HVAC tech is it an easy fix? Any help would be greatly appreciated. I will attach a couple pictures of the worst water valves. Thank you.
Plumbing – Am I able to replace these water valves on the hot water oil heater
corrosionheaterplumbing
Related Topic
- Plumbing – Particles / Debris In Faucets and Toilets – Water Softener Going Bad
- Plumbing – Washing machine shutoff valve won’t close
- Bathroom Sink Plumbing – Valve Not Working and No Access to Main Water Supply
- Plumbing Maintenance – Do I Really Need to Replace the Anode Rod?
- Plumbing – No hot water if hot water recirculator pump is shut off
- Plumbing Heating – Should Valves Stop Hot Water Flow?
- Plumbing – Hot water heater flush valves too close
- Plumbing – New Gas Line and Permits for Tankless Hot Water Heater
Best Answer
I suppose you could disassemble the handle and clean things but if that doesn't work then keep reading.
Sure, you can replace a ball valve yourself. Have you ever soldered (sweated) copper lines before? I'm going to guess not.
The biggest worry is in the second picture. If you go to heat up #2 for removal then you will likely heat up #1 to the point of failure.
By doing this yourself you will probably spend more money than having a professional do it since you need to buy:
This is really a tough job for an absolute beginner to tackle as I fully expect you to ruin your new ball valve by overheating it.
Another consideration is that you need your copper line to be fully drained of water or else you won't be able to heat it properly. If you do heat it hot enough for the old solder to melt while water is in the line then you risk a small explosion because of all the steam pressure you've built up in the line itself.