Its been 6 months and I can't quite seem to find the parts I need for this.
I Need to attach a 1/2" OD (5/8" ID) tube to a 3/4" Copper Hydronic Baseboard Element. One end the Element is enlarged to connect to another copper pipe.
What I would like to do is find out what tools I need and what parts I need to connect the two together, preferably with quick connect fittings or whatever will not require expensive tools.
I'm using a 6" Baseboard Element to passively cool a large computer system, which appears to be work beautifully, but my current solution is not very good. It currently runs at about 2PSI and 5GPM, the pump is rated to 50PSI – so I'm reasonably certain there shouldn't be any flow problems.
Can you guys help me out? I have not worked much with plumbing, and I can't seem to find barbed reducer that will fit straight up. I also don't have a clue where to look for parts.
Best Answer
Your most likely solution is to create the connector you need with two pieces - one to go from PEX (assuming that's what you have since Vinyl is not an approved plumbing material) to copper and one to go from 1/2" to 3/4".
When working with copper you generally have to sweat (aka solder) fittings, or less frequently screw them together (generally that's for end point connections like drop ears).
Lets start with what you need:
For your PEX connector, get a 1/2" to 3/4" PEX to female pipe thread connector (FPTC)
and a 3/4" - 3/4" copper male threaded adapter
Be sure to get the copper adapter that will fit over the end of your copper pipe as some adapters are sized to fit inside other fittings while others are sized to receive pipe. Test fit them in the store.
You will need to solder the 3/4" copper to the male threaded adapter. See this video:
http://www.youtube.com/watch?v=doqoEJJOdYA
Note: 3-4 seconds of solder is too long. Notice how much solder drips off of his fitting in that video. That solder is molten metal and it will land on something. 1 second is plenty - you're looking for somewhere between 1/4 and 1/2" of solder to melt and vanish into the fitting.
Allow that fitting to cool completely (use a damp cloth to speed the process), then wrap silicone tape around the male threads. Wrap in the direction of the threads, and only put about 2 layers of silicone over the threads.
Now very tightly screw the female to pex adapter onto the male threads. Make this fitting as tight as you can using two wrenches - one to hold the pipe steady and the other to tighten the fitting.
Finally insert your pex tube firmly into the sharkbite fitting of your female connector.